Question

Dear friends,

please help me on following issue
i just recently changed upper and lower arm bushings/ball joints in my Toyota hiace lh113. then i took my vehicle for an alignment checke
during the alignment checking the mechanic told me that the driver side camber nut has been already adjusted to its maximum  even if  there is a 1 ~ 2 inch negative camber. and he suggested to drill new holes in the lower arm to get ball joint 1 cm backwards.

i just want to know what would be the causes for this situation.

can you please help me on this

Share this post


Link to post
Share on other sites

3 answers to this question

  • 0

Why  don't you find the reason to deviate the Camber ?. Any deformation in the chassis or any other etc.

Drilling of  holes to shift the lower arm ball joint location is not a recommended solution,

Share this post


Link to post
Share on other sites
  • 0

yeah Rohnd thankz for the reply,

Do you know any places to give a full examination on related components? 

Edited by Surath Aravinda

Share this post


Link to post
Share on other sites
  • 0
1 hour ago, Surath Aravinda said:

yeah Rohnd thankz for the reply,

Do you know any places to give a full examination on related components? 

Not sure. However you may try places like AutoMir*j or Formul* world Seeduwa

Edited by Rohnd

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now